You are here:
PVT - Process, Voltage, and Temperature Monitor with Interrupt 7nm/6nm
The ODT-PVT-ULP-001C-7 is an ultra-low power temperature, voltage and process monitor designed in a 7nm/6nm CMOS process. This IP operates over the entire temperature range of -40C to 150C.
The temperature monitor achieves ±4C temperature accuracy without trim and ±1C temperature accuracy after a single room temperature trim.
The voltage monitor supports four differential or single-ended inputs with a voltage range up to ±1.8V.
The Process Monitor (PM) provides unique digital code based on the process mode selected using internal register read/write operation. The different modes available inside PM are intended for Dynamic Voltage Frequency Scaling (DVFS) application or process corner detection mode.
The IP has provision to program voltage and temperature thresholds. The INTERRUPT pin can be configured to indicate when either the voltage or temperature crosses the programmed thresholds.
A one-shot mode allows user to initiate an on-demand temperature or voltage measurement. When not operating, the entire block enters a low power standby mode.
The temperature monitor achieves ±4C temperature accuracy without trim and ±1C temperature accuracy after a single room temperature trim.
The voltage monitor supports four differential or single-ended inputs with a voltage range up to ±1.8V.
The Process Monitor (PM) provides unique digital code based on the process mode selected using internal register read/write operation. The different modes available inside PM are intended for Dynamic Voltage Frequency Scaling (DVFS) application or process corner detection mode.
The IP has provision to program voltage and temperature thresholds. The INTERRUPT pin can be configured to indicate when either the voltage or temperature crosses the programmed thresholds.
A one-shot mode allows user to initiate an on-demand temperature or voltage measurement. When not operating, the entire block enters a low power standby mode.
查看 PVT - Process, Voltage, and Temperature Monitor with Interrupt 7nm/6nm 详细介绍：
- 查看 PVT - Process, Voltage, and Temperature Monitor with Interrupt 7nm/6nm 完整数据手册
- 联系 PVT - Process, Voltage, and Temperature Monitor with Interrupt 7nm/6nm 供应商
Analog & Mixed Signal IP
- 7-bit, 64 GSPS ADC Ultra Low Power
- USB2.0 Host Transceiver PHY
- Analog Front End: 16x 12-bit 200 MSPS ADCs, 14x Voltage DACs, 4x 250 MSPS DACs, 4x TVM, LDO
- Analog Front End: 2x 12-bit 4 GSPS IQ ADCs, 2x 12-bit 8GSPS IQ DACs, bandgap, temp sensor, PLL, 4 x LDO
- Fibre-Channel Transceiver
- PCI Express PHY serial link PIPE Transceiver IP cell/hard macro