Terminus Circuits offers low power, low latency Multistandard SerDes in TSMC 28nm process node to support wide range of standards like PCI Express, SATA, XFI, USB, XAUI etc.
特色
- Configurable parallel data widths of 8 / 16 / 32 –bit
- Input reference 125MHz to support 2.5/5/10G data rates & 100MHz to support 2.5/5/8/16G data rates
- Tight control over termination resistor (~50 Ohm) with on chip calibration
- Tight skew control of 1UI between lanes of the PMA
- Multi-tap Tx Finite Impulse Response (FIR) equalizer with multi-level de-emphasis
- Continuous time linear equalizer (CTLE) with programmable settings providing up to 12dB gain peaking at Nyquist frequencies
- Programmable/automatic calibration of key circuits (pre-emphasis, eye-diagram monitoring / DFE tap calibration / offset calibration)
- CDR logic for better data alignment and locking
- Support for bifurcation and quadfurcation modes
- Multi-tap Rx DFE (decision feedback equalizer)
- Programmable internal/external
优势
- Single Supply:0.9V±10%, Multi Standard with Programmable Pre-Emphasis and equalizer supporting data rate up to 16Gbps
可交付内容
- GDS II Layouts
- LEF abstracts
- CDL netlists
- Liberty timings
- Verilog description
- A full datasheet
- An integration note
应用
- Enterprise routers
- Data storage
- Network communication
- Switches
- Repeaters and Re-timers