MIPI DSI Tx Controller

特色

• Interface with MIPI D-PHY following PHY Protocol Interface (PPI), as defined in MIPI Alliance Specification for D-PHY
• Supports all commands defined in the MIPI Alliance specification for Display Command Set (DCS)
• Transmission of all Command mode packets through the APB interface
• Transmission of commands in low-power and high-speed during Video mode
• Supports up to four D-PHY data lanes
• Bidirectional communication and escape mode support through data lane 0
• Supports non-continuous clock in D-PHY clock lane for additional power saving
• Supports Ultra Low-Power mode with PLL disabled
• ECC and Checksum capabilities
• Support for End of Transmission Packet (EoTp)
• Fault recovery schemes
• 3D transmission support
• System interfaces: APB/DPI/DBI
• Video pattern generator
• Support video format up to 4Kp30
• 16-bit RGB
• 18-bit RGB
• 24-bit RGB
• 30-bit RGB
• 36-bit RGB (double clock rate required)
• 24-bit YCbCr 4:2:2
• 20-bit YCbCr 4:2:2 loosely packed
• 16-bit YCbCr 4:2:2
• 12-bit YCbCr 4:2:0
• DSC24 compressed data