MIPI ASPMI Slave interface provides full support for the two-wire MIPI ASPMI synchronous serial interface, compatible with SPMI specification. Through its SPMI compatibility, it provides a simple interface to a wide range of low-cost devices. MIPI ASPMI Slave IIP is proven in FPGA environment.The host interface of the MIPI ASPMI can be simple interface or can be AMBA APB, AMBA AHB, AMBA AXI, VCI, OCP, Avalon, PLB, Tilelink, Wishbone or Custom protocol.
MIPI ASPMI SLAVE IIP is supported natively in Verilog and VHDL
- Compliant with 1.3 Apple MIPI SPMI Specification
- Full MIPI SPMI Slave functionality
- Supports following frames
- Command Frame
- Data/Address Frame
- No Response Frame
- Supports ACK/NACK as per 2.0 specs
- Support for slave requests through Alert(A) / Slave Request(SR) bit
- Support for Slave Request Hold.
- Glitch suppression (optional).
- Supports extended register read/writes
- Supports wakeup command
- Supports Authentication Command Sequence
- Supports Device Descriptor Block command Sequences
- Supports following Device Interrupts
- Edge sensitive interrupts
- Level sensitive interrupts
- Group interrupts
- SPS (System Power State) interrupts
- DVC Group interrupts
- LDO and DVC interrupts
- Interrupt priority queuing
- IRQH Enable register (Disabling of IRQ generation functionality based on NACK Retry limit)
- Generation of Group event on any internal SPMI error logged in an ERROR CTRL register
- Supports virtual wires on SPMI (Supports both scheme 1 and scheme 2)
- Supports Short Addressing Modes
- Supports Control on Register0 write and power mode command (Sleep/Wakeup/Shutdown/Reset) reception
- Supports Slave To Slave (STS) Transmit and Receive Command filtering
- Ability to generate an empty arbitration request
- Fully synthesizable
- Static synchronous design
- No internal tri-states
- Scan test ready
- Simple interface allows easy connection to microprocessor/microcontroller devices
- Slave IP can be build to have additional slave interface blocks like SPI or I2C, in addition to SPMI slave functionality
- Single Site license option is provided to companies designing in a single site.
- Multi Sites license option is provided to companies designing in multiple sites.
- Single Design license allows implementation of the IP Core in a single FPGA bitstream and ASIC.
- Unlimited Designs, license allows implementation of the IP Core in unlimited number of FPGA bitstreams and ASIC designs.
- The MIPI ASPMI Slave interface is available in Source and netlist products.
- The Source product is delivered in verilog. If needed VHDL, SystemC code can also be provided.
- Easy to use Verilog Test Environment with Verilog Testcases
- Lint, CDC, Synthesis, Simulation Scripts with waiver files
- IP-XACT RDL generated address map
- Firmware code and Linux driver package
- Documentation contains User's Guide and Release notes.
Block Diagram of the MIPI ASPMI Slave